Structural units of corrugated metal of the specified thickness.
A. Meet the requirements of AASHTO M 167 for steel or AASHTO M 219 for aluminum, except as modified in this section.
B. Connect plates at longitudinal and circumferential seams with bolts. Stagger joints so that no more than three plates come together at any one point. Curve each plate to one or more circular arcs.
A. Curve each plate to the proper radius so the cross-sectional dimensions of the finished structure will be as indicated in the contract documents.
B. Ensure the diameter of the bolt holes in longitudinal seams, except those at plate corners, does not exceed the diameter of the bolt by more than 1/8 inch. If elongated structural plate pipe is specified or called for in the contract documents, form the plates so the finished pipe is elliptical in shape with the vertical diameter approximately 5% greater than the nominal diameter of the pipe.
Use bolts that meet the requirements of ASTM A 449 or ASTM A 325 or an approved equal. Use galvanized bolts and nuts.